...
- The SRIOV network device plugin is Kubernetes device plugin for discovering and advertising SRIOV network virtual functions (VFs) in a Kubernetes host.
- We first determine which hosts are SRIOV capable and install the drivers on them and run the DaemonSet and register Network attachment definition
- On an SRIOV capable hosts, we can get the resources for the node before we run the pod. When we run the test case, there is a request for a VF from the pod, therefore the number of resources for the node is increased.
QAT
CMK
Le Yao
Optane
SDEWAN
Openness
ONAP4K8s:
- ONAP4K8s testing check the health connectivity ONAP Micro service, once it is installed
...
- Use Kud to setup 3 clusters (traffic hub, edge1, edge2)
- Create SDEWAN CNF instance and dummy pod in edge1, SDEWAN CNF instance and httpbin pod in edge2
- Configure traffic hub as responder to provide IP addresses to any authenticated party requesting for IP addresses.
- Configure edge1 and edge2 IPSec configuration to get the IP addresses.
- Establish edge1 tunnel to traffic hub, edge2 tunnel to hub, and hub policy for traffic between edge1 and edge2
- Establish SNAT rule in edge1 and DNAT rule in edge2 to enable tcp connection from edge1 to edge2's httpbin service
- Verify curl command is successful from edge1 dummy pod to edge2's httpbin service
BluVal Testing
CI logs:
The gerrit comments contains the CI log url. All the CI logs are under this folder ICN : https://jenkins.akraino.org/view/icn/job/icn-master-verify/
...